Called Vans again to get answers to yet more questions about fuel tanks

Q: How to finish securing the the trap door hinge pin?
A: They just bend one side of it (the side toward the rear of the rib, like I have already done). They depend on the joint between the rear baffle and rear rib flange as a hinge stop and don't even bother bending the other half.

Q: How to fabricate the rear-most anti hangup bracket for the flop tube assembly? I asked because the small drawings were not clear how this was supposed to be designed, and they do not provide any instructions for it either.
A: you can twist/bend it so that the face of the bracket is properly oriented on both the stiffener and the rib web. they said that using an "angle" is probably overkill. So attach one end to the stiffener and then twist/bend it forward enough so that the other end of the bracket is properly oriented 90 degrees from the other end.

Q: What thickness material and rivets to use to cover up the t-704 hole in the rear web of the first inboard tank rib. Needs to be done since all main fuel flow into this bay of the tank is supposed to be controlled ONLY by the hole in the lower rear of the rib where the trap door resides.
A: Use whatever scrap you have and put 4 rivets of your choosing to permanently cover with no proseal or anything - just cover that hole so the majority of the fuel entering that bay must come through the bottom hole with the trap door.

There are several other smaller tooling holes in the rib that will also allow fuel to move through them, but they are so small that they shouldn't matter much.

Q: Use the tank dies or no?
A: Says you are supposed to use the tank dies on the ribs, and the regular dies on the skins.

I don't think this is correct per Mike at Cleaveland Tools - I told the guy at Vans about a video that MIke had finally produced where he attempts to cover the proper use of the substructure dies, tank dies, and regular dies. I need to review that video again and make my final decision about which dies to use on which parts.

Q: Proper washer placement for the AN fittings for the flop tube?
A: There is no spacer(washer) placed on the T-405 tank attach bracket because that part already basically serves as a spacer since it is 3/16ths of an inch thick. So I just need to fab the part, cut small recesses in it where the rib flange/skin rivets are located around the very front of the rib, place the nut on the part and mark the rivet hole locations as best as possible to ensure clearance around the nut so that it can be secured with a wrench later on, and the nut is the only thing that rests against the face of the attach bracket.

Then my friend Mike Rettig supplied me with a few more answers to some Proseal questions:
Q: Buy and use the 1/2 inch wide x 1/16th inch deep spouts for the SEmco tubes to apply a coat on each rib web, or just use the circular tube tat comes with each tube?
A: Just use the circular applicator tube that comes with each tube, apply the bead on the rib flange only, and NOT the skin, and use a pop sickle stick or other applicator to spread it evenly across the width of the flange.

Then attach the ribs to the skin per Rick Gialotti's faying method as posted in VAF.

SO to finish up the trap door tomorrow I will shorten up the other end of the hinge pin, smooth it out, and proceed with making the cover plate for the other hole and riveting that in place.