Saturday, November 14, 2009
Bending the HS702 Front Spar Web to Match the Angle Support Brackets
This is the nature of the entire project - you finish one sub assembly and move on to the next challenge or problem at hand. The next step was to bend the center flange of both front spar halves to the same 6 degree angles as the support brackets. If you look closely I have drawn a mark with a black shrpie to show where the bend line is supposed to be, and took this photo to show that the bend line seems as though it might interfere with the radius of the 90 degree bend of the flange at the top of this photo. I stressed over this for some time, since I was not sure if I would have to trim this flange so that it would not interfere with the bend line.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment